What should users pay attention to when operating and maintaining PET bottle blowing machines?

2021-11-25

In recent years, with the rapid development of the domestic plastic bottle market, the plastic bottle blowing machine industry has ushered in a development opportunity. The Blow molding machine is mainly a fully automatic stretch blow molding equipment. In other words, it is a machine used to blow bottles: a Bottle Blowing Machine is a machine that can blow plastic particles (softened into liquid) or preforms into bottles through a certain production process.

The bottle is made by the bottle blowing machine so that subsequent materials can be poured into the bottle, which saves time and effort and has high blowing efficiency.
So, how do users operate the bottle blowing machine correctly, and what should be paid attention to in maintenance?

01

There are several situations that need to be checked if the feeding level is not feeding:

Whether there is no material in the hopper, if yes: need to add material as soon as possible

No: please check whether the control contactor of the hoist is energized, if it is energized, quickly check whether the motor is energized and loaded, because this situation is likely to be caused by the preform (embroid) stuck in the lift With, the easiest way at this time is to help raise it manually.

If you check that the control contactor of the hoist is not energized, please check whether the preform detection electric eye and the reflector are not in the same straight line.

02

Feeding old card feeder tray: This situation is a headache. From experience, if the length of the preform (preform) is longer and the weight is larger, then this phenomenon is relatively rare.

03

After the bottle is blown, it cannot be taken out of the mold.

First, open the mold, open and close the mold manually, if it is normal, run it in the dry running state, if it is also normal.

Please check your exhaust time setting. If the exhaust setting is normal and it fails every time you blow the bottle, then it can be judged that the exhaust valve is the problem. Please open the exhaust valve to check the condition of its spring and seal (this Another phenomenon of this kind of failure is that the exhaust sound is relatively loud or there is a sound of dirty exhaust).

If you encounter a situation where many molds are normally produced and accidentally cannot open the mold, please check whether the clamping pin has a segmented screw in it. In addition, please check whether the clamping force is too large. If it is too large, you should follow Standard readjustment.

04

Bottles are always pinched: Whether the position of the manipulator is misaligned.

05

Two manipulators collide:

In this case, you need to manually reset the manipulator again, which is caused by misalignment.

Previous: What are the common technical problems of PET blow molding machine? Next: Semi Auto 2 Cavity Blowing Machine Shipment